Saniflo SaniBEST | Macerating Upflush Toilet Kit | Pump + Elongated Bowl

Description

This SaniBEST Upflush Kit Includes
The SaniBEST macerating bathroom pump
White toilet bowl (size: elongated)
White toilet tank
Retail Price:
,434.00
Our Price:
,218.90
+ no tax + free shipping (20-30% total savings)
UPC#s 013, 087, 005
Available Product Combinations
BOWL SIZE
EXTENSION?
RETAIL PRICE
OUR PRICE
SAVINGS
BUY HERE:
Combo 1
Standard Bowl
No Extension
,401.00
,190.85
20-30%
click here
Combo 2
Standard Bowl
Plus Extension
,457.00
,238.45
20-30%
click here
Combo 3
Elongated Bowl
No Extension
,434.00
,218.90
20-30%
this listing!
Combo 4
Elongated Bowl
Plus Extension
,490.00
,266.50
20-30%
click here
SaniBEST Benefits
The SaniBEST is a system that is used to install a complete bathroom up to 15 feet below the sewer line, or even up to 150 feet away from a soil stack. The  SaniBEST pump is designed to connect with:
This  SaniBEST Upflush Toilet
Any Sink
Any Shower
Any Bath
SaniBEST Installation
The  SaniBEST is simplicity itself to install; there are just four connections.
The macerating/pump is connected to the spigot of a horizontal outlet toilet.
The toilet tank is connected to the water supply.
The macerating/pump is connected to the small diameter discharge pipe work.
The macerating/pump is connected to the electrical supply.
Then optionally connect the discharge pipes from the sink, shower and/or bath.
SaniBEST Function
The inside of the SaniBEST is comprised of a pressure chamber, which starts and stops the unit, and the motor, which drives the stainless steel cutting blade and the pump.  When the flush is activated, the water flowing into the SaniBEST activates a micro switch in the pressure chamber, which in turn starts the motor.  The motor is sealed for life in an oil filled enclosure.  A common spindle/shaft drives the impeller and the blades.  The moving parts therefore are kept to an absolute minimum.  Water and organic waste matter, enter the chamber and are reduced to slurry as the blades rotate at 3600 RPM.  The reduced solids are picked up at the bottom and the impeller mounted beneath the motor ejects the waste.
The unit pumps the effluent upward to 18 feet and/or 150 feet horizontally (with gravity fall).  Once the water level in the container goes down, the micro switch deactivates.  A normal operating cycle for the SaniBEST takes about 7-9 seconds depending upon the discharge pipe run configuration.
In addition, the SaniBEST will also discharge gray water from a variety of other sanitary fixtures such as: a sink, a bath/shower, a urinal and even a washing machine (indirect connection).  When adding a bathtub/shower, a base will have to be constructed.  This base should be made out of a 2” x 6” (minimum) or 2”x 8” (recommended) on edge, to allow for the installation of a P-trap and the required 1/4” per foot gravity flow towards the pump unit.
The wastewater from other sanitary fixtures is discharged into the SaniBEST via two 1½-inch inlets on either side of the housing.  The discharge elbow on top of the SaniBEST can be rotated 360 degrees depending on the discharge installation.  A non-return valve (included in assembly) prevents back flow into the unit.
This unit has been designed with a vent connection on the lid.  All plumbing codes require connection to a vent system.  Please note that the vent system should be a two-way air vent.  The use of mechanical vents, air admittance valves or similar devices are not permitted as these are considered one-way air vent systems.
The SaniBEST unit must be connected to our rear discharge toilet.  It is highly recommended for the grinder to be connected to a Ground Fault Interrupter (GFI) circuit.
The Sanibest has been certified to American and Canadian Standards.  Macerating standard; US: CSA Certified & IAPMO (UPC) listed - ASME A112.3.4, CA: Macerating Standard CSA B45.9.
SaniBEST Water Conservation
The water closet the SaniBEST is connected to, uses much less water than a regular toilet, it uses 6 liters (1.6 US Gal) of water per flush.
SaniBEST Product Specifications
PART NUMBERS
UPC#s 013, 007 and 005
DIMENSIONS (PUMP ONLY)
H10" x W21" x D9"
H26cm x W53cm x D23cm
MOTOR
Induction Motor
No carbon brushes or gears.
Tested over 30,000 cycles. 3600 rpm.
ELECTRICAL SUPPLY
110-115V; 60Hz; 15 Amps
Usage 9 Amps
DISCHARGE
Horizontally to 150 ft (50m)
Gravity Fall on Horizontal installations: 1/4" per ft
Pumps vertically to 18 ft (5.5m)
DISCHARGE PIPE DIAMETER
3/4"
21mm
CONSTRUCTION MATERIALS
Polypropylene, C.R.P., Stainless Steel, Neoprene
MAX TEMPERATURE
104°F
40°C
NORMAL RUNNING TIME
7–9 secs
subject to installation pipe run
WATER PER FLUSH
1.6 US gal
6 liters
VOLUME
7.35 gal/m
27 l/m
Options
Bowl Size
REGULAR
ELONGATED
BOWL
Round Front
Elongated Front
TANK
Vitreous china tank
Vitreous china tank
HEIGHT (SEAT)
16-3/4 inches
16-3/4 inches
DEPTH (OVERALL)
26-1/2 inches
28-1/2 inches
VOLUME
1.28 gpf
1.28 gpf
WARRANTY
1 year on china
1 year on china
ADA COMPLIANT
No
Yes
Extension
INSTALLATION - Visible
INSTALLATION - Behind Wall
EXTENSION PIPE NEEDED?
No
Yes
Shipping
Same day order processing
Same day shipping
Shipping via UPS, tracking number provided
Ship to contiguous USA, no PO Boxes
Payment
Paypal, Credit Cards
Returns
Within 30 days, unopened, resalable packages; Buyer pays return shipping.
Customer Support
Full phone support is provided to all our customers. Satisfaction is guaranteed.
You'll receive a direct support phone number with your order confirmation email.
About Us
Top rated, authorized SaniFlo dealer
Over 30 years’ experience
New to eBay, but veteran in online sales
We provide our customers:
Full Phone Support
2 Year Warranty
Contact Us
We have SaniFlo experts waiting and all questions,during business days, are answered within 2 hours!